Marshall Electronics Network Control Box for IMD Monitors NCB-1004 Instructions d'exploitation télécharger pdf (Page 9)

Connecting to the NCB-1004 (continued)

Connecting the NCB-1004 to a Local Area Network

If the network portion of the unit’s IP address (first three numbers) matches your network, the NCB-1004 can be

connected to a local area network and accessed from any computer on the network. The unit’s IP address must also be

available on the network and reserved for the NCB-1004.

1. Connect the NCB-1004 to the network, using a standard ethernet cable:

2. Using any computer connected to the network, enter the unit’s IP address in a web browser to access the

NCB-1004 web interface.

3. If successfully connected, the web interface of the NCB-1004 will be shown in the browser windows as shown

below:

Network

Ethernet

cable

Ethernet

cable*

NCB-1004

* In general, a standard “straight” ethernet cable should be used. If the network hub’s

ethernet jack is not auto-switching, it may be necessary to use a cross-over cable.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Pas de commentaire

Marshall Electronics Network Control Box for IMD Monitors NCB-1004 Instructions d'exploitation Page 9